10. CONTROL BOXES AND TEMPLATES THROTTLE OPENING ADJUSTMENT With this remote control box, the throttle opening can be adjusted by using the following procedure: Control Lever Tension Adjustment M THROTTLE FULL \ 1 LOCK NUT \ STOPPER BOLT\ \ By turning in or out the throttle friction screw at the rear of the remote control box, the stiffness of the control lever can be adjusted. Turning the screw to the right makes the control lever stiff to turn, and turning it to the left makes the lever easier to turn. REMOTE CONTROL INSTALLATION POSITION Select the remote control installation position on the boat. Do not bend the cables and harnesses sharply.
Route the cabled harnesses with the bending radius of 406 mm (16.0 in) or more. THROTTLE \ - \ LOCK NUT STOPPER BOLT LESS THAN T 1Omm (0.4 in) 1. To set amount of throttle advance in FORWARD gear, loosen lock nut and set throttle opening by turning stopper bolt. 2. To set amount of throttle advance in REVERSE gear, loosen lock nut and set throttle opening by turning stopper bolt. Clockwise rotation-decreased throttle opening. Counterclockwise rotation-increased throttle opening. Obtain adequate space between the bottom of the remote control and the surrounding parts so that the remote control does not interfere with any of the surrounding parts (steering wheel, etc.).
Do not allow the stopper bolts to project more than 70 mm (0.4 in ) above the top ofthe nut. Install the remote control in the position that allows proper remote control lever operation, and where the cables and harnesses can be routed properly without strain between the remote control and the outboard motor. 3. After adjusting, tighten the locknut. TORQUE: 5-8 N*m (0.5-0.8 kg-m, 3.6-5.8 ft-lb) Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 10134