10. CONTROL BOXES AND TEMPLATES ~ HEX HEAD,BOLT /SHIFT ARM ASSEMBLY 10. Set the brake disk and brake shoe assembly on the throttle arm asembly, and install the throttle shaft. Push in the brake shoe hook until it fits into the hole in the throttle shaft. 11. Install the plain washer and circlip on the throttle shaft. 12. Make sure the cam plate aligns with the cam groove (for push-to-open throttle) and the throttle lever roller. Make sure the circlip is correctly fitted in place. 13. Install the dwell plate retainer, mounting flange, back plate, packing and cover according to page 10-32. 7.
Loosen the hex head bolt, and install the shift arm assembly, while holding it in an inverted position. TORQUE: 5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft) Install the throttle shaft on the opposite side to the original position, with the two hex head bolts. TORQUE: 5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft) 8. 10 mm (0.4 STOPPER BOLT 9. Loosen the lock nuts, and reverse the right and left stopper bolt positions, and secure the bolts with the two lock nuts. TORQUE: 5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft) Do not allow the stopper bolt to project more than 10 mm (0.4 in) from the nut surface. ClRCLlP BRAKE HOOK Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 10133