10. CONTROL BOXES AND TEMPLATES FLUSH MOUNT REMOTE CONTROL INSTALLATION (right-hand handle) This section explains the installation procedure of the right-hand handle remote control. The left-hand handle remote control can be installed in the same manner. When the mounting plate (hull) is more than 30 mm (1.18 in), the installation of the remote control box is impossible. TEMPLATE CABLE CLAMP 5. Apply marine grease to both the shift and throttle pins at the end of each arm. 6. Install the gearshift control cable groove in the housing clamp groove. Insert the cable end into the pin at the end of the shift arm and secure with an E-ring. 7. Insert cable clamp spacer in clamp groove. 5 .
MOUNTI~G SURFACE 1. Attach the drilling template to the remote control mounting surface using adhesive tape. 2. Drill the installation holes and cut out the center. 3. Pass the remote control wire harness and the control cables along the route properly. THROTTLE cable ends. 8. Apply marine grease to the throttle cable pin where it connects to the throttle arm. 9. Connect the throttle control cable to the throttle arm, in the same manner as the gearshift control cable, with an E-ring. INNER HOUSING ------Y 4. Remove the screws and remove the back plate from the inner housing. 10-36 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.