10. CONTROL BOXES AND TEMPLATES CONTROL LEVER LIMIT ADJUSTMENT (BF25/30/40/50 models only) The forward and reverse throttle limit stop screws on the premium remote controls are pre-set for the BF75/90/115/130 outboard motors. If these remote controls are to be used on the BF25/30/40/50, it is necessary to perform the following adjustment procedure. WIRE HARNESS CONNECTIONS When using optional harnesses: Check whether wire harnesses are connected as shown on the wiring diagrams on the following pages. Connect leads and terminals securely, and waterproof to prevent moisture from entering and corroding the connector terminals. 1. Remove the cover by removing the two screws. 2.
Set the control lever in the neutral position, push the fast idle button, and carefully move the control lever forward to the full throttle position. Observe the following wire harness connector instructions: If the standard 16.5 foot switch panel-to-engine cable harness is too short, please see the Honda Marine Accessories Catalog (M0045) for available harnesses. THROTTLE ARM Maximum combination lengths follow: One or two 7 ft cable harness extensions + one standard 16.5 ft cable harness = maximum length 30.5 feet. One 30 ft cable harness + one or two 7 ft cable harness extensions = max. length 44 feet. Connect wire harness securely.
If a terminal is oxidized or corroded, remove the oxidation or corrosion with a non-conductive plastic scrub pad or contact cleaner before reconnecting it. Make sure insulators completely surround connectors and that ends are not folded up. Do not break the coverings of the wire harness. If the coverings are broken, either repair them with electrician's tape, or replace them. Use vinyl tape to attach any unused terminals to the adjacent main harness to keep them from interfering with surrounding parts. THROTTLE CABLE THROTTLE ROD -A@=- i!iTTLE 3. Check at the outboard motor and verify the throttle arm is against its stop.
If not, refer to the appropriate model-family section for the model you are performing the installation on, and adjust the throttle rod or control cable. 4. Loosen the stopper bolt on the reverse side by loosening the lock nut. 5. With the control lever in the full throttle position, turn the stopper bolt out (counterc1ockwise)l - 2 turns, then gently turn the stopper bolt in (clockwise) until it just stops. TORQUE: 5-8 N*m (3.6-5.8 ft-lb) 7. With the control lever in the full throttle position, After connecting each harness, turn the main power on to check for proper operation. recheck at the outboard motor that the throttle arm is against the full throttle stop. Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co., Inc. 10140