10. CONTROL BOXES AND TEMPLATES pi%q REMOTE CONTROL CABLE CONNECTION N NEUTRAL Check that the cables are not sharply bent (less than 406 mm (1 6 in) in radius) or unnecessarily bent. (The number of bends should be minimized.) Also, check that no portions of the cables are clamped so hard as to deform the cable outers. 4. After connecting the cables to the engine, move the control lever through all functions several times and check for smooth operation at the engine and remote control box. Next, firmly secure the remote control box (which is FORWARD temporarily held with the screws) to the hull.
According to the instructions given in the respective outboard motor owner's manual, connect the remote control cables for both shifting and throttle and wire harness to the engine. When connecting, set the control lever to NEUTRAL. Operate the control lever a few times, check to see that the lever is turned to FORWARD or REVERSE until it stops once (about 35"), the gear shifts, and that when the lever is turned further from this position to FORWARD, the throttle fully opens. Next, make sure that when the control lever is returned to NEUTRAL, the throttle is completely closed. If not fully closed, adjust the positions of cable ends on the engine side, and install them again. pEl 1. 2.
The cable ends on the engine side must be screwed in at least 8 mm (0.3 in) over the remote control cables to prevent the ends from growing weak, causing them to flex and break. Move the control lever several times from lock to lock and make sure that when it is returned to the NEUTRAL position, the throttle lever on the engine side is set to the full-closed position. If not in the NEUTRAL position, the cable end on the engine side must be adjusted. Next, push the fast idle button and turn the control lever downward until it stops, then make sure that when it is returned to the NEUTRAL position, the fast idle button is automatically reset.
If not, the throttle lever on the engine side is forced against the stopper or it is not in the full-closed position. Adjust the cables so that the fast idle button can reset automatically. 3. 10-39 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.