honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES ADJUSTING SCREW HOLE 18. Install the control lever on the remote control box. i' '\ POWER TRIM AND TILT SWITCH WIRE ----__ 19. Place the set washer in the boss of the control lever, and fasten it with the screws and wave washers. TORQUE: 3-4 N*m (0.3-0.4 kg-m, 2.2-2.9 ft-lb) 14. Install the cover on the base by aligning the adjusting screw holes in the cover and the base. POWER TRIM AND TILT SWITCH WIRE \ \ FAST IDLE BUTTON 20. Install the shaft button in the hole in the accelerator shaft and install the fast idle button. 15. Wind the trim switch wire two turns counterclockwise around the boss at the lower end of the control lever.

Make sure the wire is not twisted and the white line portion of the wire is positioned at the lower end of the control lever. If the wire is twisted or wound incorrectly, it June break. Coil the wire so that windings do not cross each other. 16. Bring the white line portion of the trim switch wire to the hole in the neutral lock holder, and insert the neutral lock holder into the base. 17. Pass the trim switch wire through the holes in the mounting plate and base, and bring them to the back of the mounting plate. 21. Install the remote control box mark on the cover. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 10138