2. BF8DIBF9.9D TRANSOM DRILL FIXTURE Small Bracket (Types SH, SHS, LH, LHS) 192 mm (7.6 in) r- (3.7 in) P 95mm 8.2 mm 2 (80.3 in) I / b B B@ TRANSOM DRILL FIXTURE I Use the upper and lower holes. 1. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 mm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stern bracket. 4 90’ B B 0 D C I Use the upper holes. Drill two holes with a “ Q drill bit. 2. Drill four holes with an 11 mm drill bit. Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co., Inc. 217