3. BFlSDIBF20D INSTALLATION HEIGHT RECOM M EN DATl ON S TRANSOM DRILL FIXTURE Shaft Length Outboard Workable Boat Transom Height Transom Height B B 0 TRANSOM DRILLING See also “USING THE TRANSOM MOUNT DRILL FIXTURE” on page 1-23. I Use the upper and lower holes. Description I PartNo. I I I Transom Mount Drill Fixture I 07MPZ-ZV3010C I 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 mm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stern bracket. 4 90” 1.
Set the outboard motor onto the boat transom and verify the installation height is correct. ,. 244mm,;.6in) , TRANSOM BOARD TOP E F The BF15D and BF20D outboards motors are designed to be installed on a boat transom with the following transom board thickness: I Boat Transom Board Thickness--- -1 35 - 57 mm (1.3 - 2.2 in) 2 = E; 3. Drill four holes with an 11 mm drill bit. 128 mm (5.0 in)‘ Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 316