honda — BF15D/BF20D

3. BFlSDIBF20D Small Bracket (Types SHY LH, LHS, XH) Power Tilt Bracket (Types SHT, LHT, SRT, LRT, XHT, XRT) 1. Do not use the transom drill fixture for these 192 mm (7.6 in) r ! 7 \ I i 95 mm i (3.7 in) i i i brackets. 244 mm (9.6 in) l----. 8.2 mm (00.3 in) 1 TRANSOM DRILL FIXTURE @ B B @ 252 mm 19.9 in) 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). Use highest holes in the upper bracket. Be sure the upper bolt holes are not located above the position shown in the drawing less than 57 mm (2.2 in) from the top of the transom. Lower bolt holes should be in the top of the bracket slots.

Wear safety glasses and drill pilot holes using a 3-5 mm (118-3/16 in) drill bit. Finish drilling the holes using a 10.2 mm (13132 in) drill bit. Drill at right angles to the transom. Use the upper holes. 1. Drill two holes with a drill bit. 3. 4. 317 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.