honda — BF15D/BF20D

3. BF15DIBF20D INN LOCKING NUT (2) 118 N-rn (1.8 kgf-rn, 13 Ib-fl) I STEERING PLATE NUT 4 (marine grea 310-24 UNF BOLT \ \ \ n l STEERING LINK ROD (marine grease) SELF-LOCKING NUT (see step 7 below) 4. Install the steering link rod between the steering plate on the motor side and the cable end using the bolt, washers, nuts, and collar as shown. 5. Connect the steering link rod to the inside hole of the steering plate. Do not mount anything in the outer hole of the steering plate. 6. When connecting the link rod with the cable end, turn the outboard motor and steering wheel to the port side. Apply marine grease to the collar and steering link rod as shown before installation. 7.

Turn steering wheel to retract steering cable into the steering/tilt tube. Tighten self-locking nut, then loosen self-locking nut 1/8 turn. TORQUE: 8-11 N*m (7-8 ft-lb) 8. After attaching the cable, turn the steering wheel to the right and left, checking the steering angle. If necessary, adjust at the steering cable side, until both angles are even. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 319