4. BF25NBF30A REMOTE CONTROL CABLE INSTALLATION THROTTLE CONTROL 6 x 28 mm BOLT (2) PIVOT SHAFT (2) SEPARATE COVER SHIFT CONTROL CABLE CABLE CLAMP PLATE HARNESS BAND B edgelside against HARNESS \ I ’WIREBAND I 1. Connect the control cables to the outboard motor with the remote control lever in the neutral position and the choke/fast idle lever in the lowest (idle) position. I 6 x 40 mm BOLT (2) 2. Pass the main engine wire harness and control cables through the grommet as shown. Attach the cable clamp plate to both control cables by aligning the grooves in the cables with grooves in the cable clamp plate. Then install them into the engine undercase.
Connect the control box wire harness to the outboard motor wire harness and secure the connector to the holder as shown. Secure the wire harnesses into place as shown above using harness band A and B. Clamp harness band A around the control box wire harness and to the left side of the wire band. Snap harness band A into the holder. Make sure there is enough clearance between the control cable and the wire harness. 3. THROTTLE CONTROL CABLE /SHIFT CONTROL CABLE 4. HARNES BAND A CABLE CLAMP 5. CONTROLBOX I(! WIRE HARNESS 1 I CLE HARNESS BAND A 44 1 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.