honda — BF25A/BF30A

4. BF25NBF30A PIVOT SHAFT \ / WASHER LOCK NUT SEPARATE TOP CONTROL CABLE (marine grease) 6. Thread the lock nuts all the way on the control cables. Thread the pivots shafts onto the control cables. Apply marine grease as shown. 7. Verify that the shift arm on the outboard motor is in the neutral position, or that the control lever at the remote control box is in the neutral position. / SHAFT OCK NUT edgelside against painted surface. n I 1 1 + BOAT u I I 9. Install the separate top cover and tighten the bolts securely. Install the washers with the rounded edgehide against the painted surface to prevent paint damage and corrosion.

WASHERS I DO NOT FORGET TO INSTALL.] SHIFT CONTROL 6 mm LOCK PIN THROTTLE CONTROL CABLE 8. Connect the control cables to the shift arm and throttle arm using the 6 rnrn washers and lock pins as shown. Use the 6 mrn washers on both sides of the arm. Do not forget to install the washers. If the hole in the shift arm and the pivot shaft do not align, turn the pivot shafts in or out to align the pivot pin with the shift or throttle arm holes as necessary. Turn the lock nut up to the pivot shaft, then tighten the lock nuts securely. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 411 2