4. BF25AIBF30A CONTROL CABLE LENGTH ADJUSTMENT INDEX MARKS PIVOT ROLLER THROTTLE CONTROL CABLE 1. Put the remote control lever in the neutral position. 2. Disconnect the throttle control cable from the throttle arm. I THROTTLE CAM THROTTLE ARM 7. Verify the center of the pivot roller aligns with the index marks on the throttle cam. 8. If not, loosen the throttle control cable lock nut, disconnect the throttle control cable and turn the pivot shaft until adjustment is correct. 9. After the adjustment, reconnect the throttle control cable and tighten the lock nut securely. 10. Move the remote control lever and verify the following: CARBURETOR THROTTLE LEVER THROTTLE ROD 3.
Move the throttle arm to the fully-open position until it touches the stopper, and verify that the carburetor throttle lever touches the stopper in the fully-open position. 4. If not, loosen the lock nut, disconnect the throttle rod from the throttle cam, and adjust the throttle rod length by turning the linkage pivot. The control lever moves smoothly into all positions. The carburetor throttle lever moves smoothly without binding from the fully-opened to the full y-closed position. SHIFT CONTROL CABLE LOCK NUT THROTTLE CAM 1. Move the remote control lever to the REVERSE position. 2. Disconnect the shift control cable from the shift arm. DETENT ROLLER I I LINKAGE PIVOT THROTTLE ROD 5.
After the adjustment, connect the throttle rod to the throttle cam and tighten the lock nut securely. 6. Reconnect the throttle control cable to the throttle arm. \ SHIFT LINK B 3. Verify the detent roller is in the center of the groove on the shift link B at the (R) mark. 411 3 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.