honda — BF40A/BF50A

5. BF40NBF50A INSTALLATION HEIGHT RECOMMENDATIONS TRANSOM DRILL FIXTURE Shaft Length I Boat Out board Transom Height Transom Height @ B B@) TRANSOM DRILLING See also “USING THE TRANSOM MOUNT DRILL FIXTURE” on page 1-23. U U I Description I P a r t ~ o . I I Transom Mount Drill Fixture I 07MPZ-ZV301OC I Use the upper and lower “C” holes. 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 rnm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stern bracket.

The BF40A and BF5OA outboards motors are designed to be installed on a boat transom with the following transom board thickness: I Boat Transom Board Thickness 35 - 57 mm (1.3 - 2.2 in) 1. Set the outboard motor onto the boat transom and verify the installation height is correct. Unit: mm (in) d X PI In; 67 TRANSOM gOARD TOP mc! 2 In 3. Drill four holes with a 17/32 drill bit. 517 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.