5. BF40AIBFSOA STEERING CONNECTIONS Do this before final placement of the motor on the transom. Refer to the steering cable manufacturer’s manual for cable handling procedures. CAP (2) . . .--.-= 1. Remove the left and right caps from the steering/tilt tube. Apply marine grease to the steering cable and install the steering cable through the steeringhlt tube. Do this before final placement of the motor on the transom. Position the motor on the center line. Line up the drilled holes in the transom with the holes in the stern bracket. Hand tighten the steering cable nut at this time. 2. 3. 4. 5. Install the sealed cap on the steeringhilt tube.
Below is a list of two optional steering tube seals which are available and include a grease fitting. I Description I Part No. I I Stainless steel I 50899-ZV5-020AH I I Anodized aluminum I 50899-ZV5-000AH I Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 5 8