honda — BF40A/BF50A

5. BF40NBF50A STEERING LINK ARM INSTALLATION FORWARD 10 mm STAINLESS PLAIN WASHER (3) If the steering cable enters the tiltlsteering tube from the port side, use the forward hole. Otherwise, do not mount anything in the forward hole of the steering plate. This hole is usually used for dual motor installations. 1. Install the steering link arm into the inside hole of the steering plate using the bolt, washer, nuts and collar as shown. Lightly seat the inner nut against the collar, then thread the bolt into the steering plate and tighten securely. Hold the bolt and tighten the nylon lock nut. TORQUE: Nylon lock nut: 27.1 N-m (20 ft-lb) 3.

Turn steering wheel to retract steering cable into the steering/tilt tube. Tighten the lock nut, then loosen the lock nut 1/8 turn. TORQUE: 8-11 N*m (7-8 ft-lb) STEERING CABLE ATTACHING NUT 4. Tighten the steering cable attaching nut until the steering cable end play is removed. TORQUE: 14 N-m (10 ft-lb) After steering cable nut is tightened, there should be no end play between outer steering cable and steering tiltltube. For further information regarding steering cable, refer to the boat manufacturer’s operation manual. Directly after completing the steering link arm and steering cable installation, verify the following: 10 PL / NYLON LOCK NUT 5. 2.

Turn the steering wheel to extend the steering cable out of the steeringhilt tube. Install the steering link arm into the steering cable end using the washers and lock nut as shown. Motor turns the proper direction when the steering wheel is turned right and left. If the steering is reversed, correct at the steering box. 519 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co.. Inc.