honda — BF40A/BF50A

5. BF40AIBF50A REMOTE CONTROL CABLE INSTALLATION PIVOT SHAFT (2) 6 x 28 mm SELF- TAPPING BOLTS (2) SEPARATE TOP CONTROL BOX WIRE HARNESS 6 mm STAINLESS CONTROL CABLE HARNESS CLIP edgekide against 6 mm LOCK PI STAINLESS BOLT (2) 1. Connect the control cables to the outboard motor with the remote control lever in the neutral position and the chokelfast idle lever in the lowest (idle) position. 2. Pass the control box wire harness and control cables through the grommet as shown. CONTROL BOX THROTTLE WIRE HARNESS CONTROL CABLE sH,FT / \ CONTROL CABLE LOCK NUT CONTROL CABLE 5 mm (0.2 in) MlNlMU , I . CABLE CLAMP PLATE 3.

Screw the pivot shafts onto the threaded portions of the throttle and shift cables as shown. 4. Attach the cable clamp plate to both control cables by aligning the grooves in the cables with grooves in the cable clamp plate. Then install them into the engine undercase. 5. Verify that the shift arm on the outboard motor is in the neutral position, and that the control lever at the remote control box is in the neutral position. 5 4 1 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.