5. BF40AIBFSOA 6. Apply marine grease to the pins of the pivot shaft. CONTROL BOX WIRE HARNESS \ PIVOT SHAFT 6mmLOCKPIN (krg. b P ) WASHERS 7. Connect the control cables to the shift arm and throttle arm using the 6 mm washers and lock pins as shown. Use the 6 mm washers on both sides of the arm as shown. Tighten the lock nuts securely. HOLDER SHIFT CONTROL CABLE NOTE DIRECTION I 9. Secure the main engine wire harness with the harness clip. 6 x 28 mm SELF- TAPPING BOLT (2) SEPARATE TOP COVER - .-.._ CONTROL CABLE If the holes in the shift arm and pivot shaft do not align, adjust by turning the pivot shaft in or out as necessary. 8.
Connect the control box wire harness to the outboard motor wire harness and attach the connector to the holder. Install with rounded edgelside against painted surface. BOLT (2) I 1 10. Install the separate top cover and tighten the bolts securely. 5-1 2 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.