5. BF40NBF50A COMMON PROCEDURES Always make sure all bullet connector boots are properly seated. Four Wire Connector A four wire blue connector was used on all models prior to the BF40A3 BF50A3 and a four wire black connector is used on all BF40A3 BF50A3 models. Refer to page 5-20 for connector location. Combinations 1, la, 3b 1. Use a small piece of safety wire or terminal pin tool F to remove the rubber plug. Remove and discard. +- RUBBER PLUG I I 2. Depending on the combination, insert the optional light greedblack 20 inch wire or the VCM wire spade terminal into connector. I , - --- ------ I Make sure the wire seal is pushed all the way into the connector.
Lightly pull on the wire to make sure the terminal is locked in place. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 511 8