Data N38143 Pipe size: • Supply - Outside diameter......................................... 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................ 4.93mm (0.194”) Maximum lift pump lift (clean filter)...........0.8m (2.6ft) to bottom of tank suction pipe Maximum fuel lift pump depression at inlet...................
127mm (5”)Hg Fuel consumption at full power...............................5.2 l/hr (1.4 US galls/hr) 6.2 l/hr (1.6 US galls/hr) Air Intake Combustion airflow........................1.46 m3/min (51.5ft3/min).........1.76m3/min (62 ft3/min) Maximum engine compartment air temperature.............60 o C (140 o F) Maximum air temperature at engine inlet........................52 o C (126 o F) Ventilation - maximum engine room depression.....................................................125mm H 2 O (5 in H 2 O) Minimum cross section of air duct (per engine)..................................103cm2 (16sq ins) for hot climates. ...............................................................
52cm2 (8sq ins) for temperate climates. Exhaust Exhaust gas flow............................4.13m3/min (146ft3/min)......... 5.01m3/min (177ft3/min) Maximum restriction measured within (305 mm) 12” outlet..........................................10.21kPa (3.0” Hg) Recommended pipe bore (wet exhaust)....................... 63.5mm (2.5”) Recommended pipe bore (dry).......................................50mm (2.0”) Minimum rise from sea water level to exhaust outlet centreline............................................203mm (8.0”) Lubricating System Recommended lubricating oil.................................... AP1 CH4 ACEA E5 Sump capacity maximum...................................
10.6 litres (2.7 US galls/min) Normal operating angles....................................25 o continuously at all angles Oil pressure, in operating speed range (steady state)...........................................200kPa (29psi) Low oil pressure switch setting......................................80kPa (12psi) Electrical System Generator..........................................................................55A (12V) Starter...........................................................................
12 volt 2.0 kW Number of teeth in flywheel....................................................126 Number of teeth on starter.......................................................9 Cold Start Limits Minimum cold start temperature (with aid)....................... -15 o C(5 o F) Batteries for min cold start............................... 1 x 12 volt 540 Amp to BS3911 ..................................................................or 1 x 12 volt 740 amps to SAE J537 Page 70