Data N38143 Pipe size: • Supply - Outside diameter.........................................7.9 mm (0.315”) • Supply - Bore............................................................6.53 mm (0.257”) • Return - Outside diameter..........................................6.3 mm (0.25”) • Return - Bore............................................................4.93 mm (0.194”) Maximum lift pump lift.............................1.53 m (5 ft) to bottom of tank suction pipe.
Maximum fuel lift pump depression at inlet................120 mm (4.72”) Hg Fuel consumption at full power.......6.7 l/hr (1.8 US galls/hr) ..........7.4 l/hr (2.0 US galls/hr) Air Intake Combustion airflow..........................1.8 m3/min (65 ft3/min)........... 2.2 m3/min (77 ft3/min) Maximum engine compartment air temperature............60 O C (140 O F) Maximum air temperature at engine inlet.......................52 O C (126 O F) Ventilation - maximum engine room depression.....................................................125mm H 2 O (5 in H 2 O) Minimum cross section of air duct (per engine)..................................135 cm 2 (21 sq ins) for hot climates.
..............................................................71 cm 2 (11 sq ins) for temperate climates. Exhaust Exhaust gas flow............................5.0 m3/min (175 ft3/min)........ 5.75 m3/min (203 ft3/min) Maximum restriction measured within (305 mm) 12” outlet..........................................10.2 kPa (3.0” Hg) Recommended pipe bore (wet exhaust).......................63.5 mm (2.5”) Recommended pipe bore (dry)...................................... 40 mm (1.6”) Minimum rise from sea water level to exhaust outlet centreline...........................................
203 mm (8.0”) Lubricating System Recommended lubricating oil..................................AP1 CD/SE CCMC D4 Sump capacity maximum...................................... 15 litres (4 US galls/min) Normal operating angles...............................25 O from horizontal in any direction Oil pressure, in operating speed range (steady state)................................310 to 390 kPa (45 to 57 psi) Low oil pressure switch setting.....................................
83kPa (12 psi) Electrical System Generator..........................................................................70A (12V) Starter type..........................................................Magneti Marelli 12V 2.5 kW Number of teeth in flywheel....................................................126 Number of teeth on starter......................................................10 Cold Start Limits Minimum cold start temperature (with aid).......................-15 O C(5 O F) Batteries for min cold start........................1 x 12 volt 540 Amp SAE (340 Amp IEC) Page 72