Perkins — Page 1

Data N38143 Pipe size: • Supply - Outside diameter ........................................ 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................ 4.93mm (0.194”) Maximum lift pump lift (clean filter)........... 17kPa at 1.7m using 8mm dia. bore pipe Maximum fuel lift pump depression at inlet...................127mm (5”) Hg Fuel consumption at full power......18.6 l/hr (4.9 US galls/hr) .........

22 l/hr (5.8 US galls/hr) Air Intake Combustion airflow................................................. 7.3 m 3 /min (258 ft 3 /min) 9.4 m 3 /min (332 ft 3 /min) Maximum engine compartment air temperature............60 O C (140 O F) Maximum air temperature at engine inlet.......................52 O C (126 O F) Ventilation - maximum engine room depression.....................................................125mm H 2 O (5 in H 2 O) Minimum cross section of air duct (per engine).................................358cm 2 (55.5sq ins) for hot climates. ...............................................................81cm 2 (28sq ins) for temperate climates.

Exhaust Exhaust gas flow............................17.7m 3 /min (625 ft 3 /min)......... 21.2m 3 /min (749 ft 3 /min) Maximum restriction measured within (305 mm) 12” outlet............................................15kPa (4.4” Hg) Recommended pipe bore (wet exhaust)........................100mm (4.0”) Recommended pipe bore (dry)..................................... 76.2mm (3.0”) Minimum rise from sea water level to exhaust outlet centreline............................................203mm (8.0”) Lubricating System Recommended lubricating oil........................... AP1 CG4/CH4 or ACEA E3/E5 Sump capacity maximum......................................

15 litres (4 US galls/min) Normal operating angles...............................25 O from horizontal in any direction Oil pressure, in operating speed range (steady state).......................................... 250kPa (36 psi) Low oil pressure switch setting.....................................

83kPa (12 psi) Electrical System Generator................................................................100A (12V), 55A (24V) Starter type......................................................................12 V 4.0 kW Number of teeth in flywheel....................................................126 Number of teeth on starter......................................................10 Cold Start Limits Minimum cold start temperature (with aid).......................-15 O C(5 O F) Batteries for min cold start....................................1 x 12 volt 660 amp SAE Page 82