. OPERATION OPERATION 10 to -30 ° C (50 to -22 ° F) Change 0 to 20 Engine Cooling Water Auto Warming-up Function Auto warming-up function warm up engine cooling water more quickly by raising an engine idling speed above 1200 rpm when the ambient temperature is low. When the turbocharger protection function and engine cooling water auto warming-up function are activated at the same time, the former takes priority over the latter. While the auto warming-up function is in operation, the engine speed is held at 1200 rpm even if the fuel control dial is set below 1200 rpm.
However, if the fuel control dial is held at the MAX position for more than three seconds, the auto warming-up function is canceled and then the engine speed can be lowered below 1200 rpm. This function continues to work for a maximum of 10 minutes, or until the engine cooling water temperature reaches 30 ° C (86 ° F). If the deceleration pedal is depressed while this function is in operation, the auto warming-up function is canceled and the engine speed goes down below 1200 rpm. 3 - 114 7.
When t he engine ro tation stabilizes, retu rn to the low idle (MIN) position o f fuel control d ial ( 1) and then carry out rming-up op eration REMARK Regard less of the a mbient temperature, if the key in starti ng switch ( 2) is tu rned from OFF p ositio n to lef t, engine pre hea ting monitor (3) wil l light up and preheating will sta rt. (Preheating continues while t he starting s witch (2) is held at the left.) e preheat time, see the table in step 5. For the details of th e preheat time, see t he table in step 5 While p reheating is being carried out, en gine pre-heating monitor (3 ) ligh ts up to s how tha t preheating is being carried out.
gine does not start with the above operation, wait for about 2 minutes, and repeat steps 3. and 4. If the en gine does n ot star t with the abo ve operation, wai t for about 2 minutes, and repeat steps 3. an Turbo prote ct function The turbo protect funct ion is a function to p rotect the turbocharger by k eepin g the engine speed at less th an 1000 rpm imme diately after t he engine is started . When the t urbocharger protection function and engine coolin g water au to warming-up functio n are a ctivat ed at the same time , the former takes priority over th e latter.
is in operation, the engine speed is held at 1000 rpm even if the fuel While th e turbochar ger protect function ove 1000 rpm. control d ial is set ab When th e turbo prote ct function is cancel ed, the engine spe ed is set to the s peed for t he p osition of the fue l control dial. The rela tween turbo pr otect functio n and t he temperatur e of the engine co olant is as sh own in the ta