Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CAUTION outer element in position, then secure cover (1) and return the yellow 4 - 22 When installing the c over (3), check O-ring ( 7) and replace it if t here are an scratches or damage . 10. (3) with mounti 11. Push the butt on of dust indicator piston to its ori ginal position. 12. Close the left e ngine side cover. 13. If the yellow pi ston in dust indicator (1) overlaps the red zone on the outer diameter im mediately after the outer element is clea ned, replace both th e inner and out er elements. REPLACING ELEM 1. Open the left e 2. Remove three clips (2), then remo ve cover 3.

Holding outer element (4), remov ie it by swing it careful vertically and h orizontally and rotat ing it to the righ t and left. Do not remove inner element (5) a t this time. aner body, cov er (3) an thers. 4. Clean the inte rior of the air cle evacuator valv e (6) with a clean cl oth, a whisk or o NOTICE nt and cover are installed while the inner element is not installed properly, the outer element may break. is correct, protrusion "a" of the inner element from the air cleaner body is 35 mm (1.4 in). euse the inner element. When replacing the outer element, replace the inner element with new one, too.

If the outer eleme nt and cover are install ed while the inner element is no t installed properly, the o When installation is correct, protrusion " a" of the inner ele ment from the air cleaner body is 35 m Do not clean and r euse the inner elemen t. When r eplacing the outer element, replace the inner ele Avoid using a non -genuine element, sin ce the accuracy of its seal is low and dirt will enter and ca n cause an engine trouble.