. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 21 Do not leave or keep the filter ele ment in a place where it will be exposed to the direct sunlight before an d after cleaning it. Never remove inner element (5) . If it is removed, dirt will enter and can cause an engine trouble. Do not use a screwdriver or ano 3. Hold the outer element (4), move it carefully up and down and to the left and right, and rotate the element to the left and right while pulling it out. 4. After removing the outer element, cover the air connector inside the air cleaner body with a clean cloth or tape to prevent dirt or dust from entering. 5.
Clean the interior of the air cleaner body, cover (3) and evacuator valve (6) with a clean cloth, a whisk or others. 6. Blow dry compressed air (Max. 0.20 MPa (2 kg/cm2, 28.4 PSI)) from the inside of the element along its folds. Then blow the compressed air from the outside along the folds, and again from the inside. NOTICE If small holes or thinner parts are found on the element when it is checked with an electric bulb after cleaning and drying, replace the element. When cleaning the element, do not hit it or beat it against something. Do not use an element whose folds or gasket or seal are damaged.
If small holes or thinner parts are f ound on the element when it is checked with an electric bulb after cleaning When cleaning the element, do not Do not use an element whose fold 3. Hold the outer element (4), move it carefully up and down and ate the element to the left and right 5. Clean the interior of the air cleaner body, cover (3) and evacuator valve (6) with a clean cl oth, a whi sk or ot hers. 6. Blow dry compressed air (M ax. 0.20 MPa (2 kg/cm2, 28.4 PSI)) 7. Remove the clothe or taps used as a cover in Step 3. 8. Check that there is no dirt or oil stuck to the seal portion of the new eleme nt or cleaned element. Wipe of f any dirt or oil.
NOTICE The inner element must not be c leaned and used again. When replacing the outer element, replace the i nner element at the same time. If the inner element is not instal led properly and the outer element and cover are installed, there is d damaged. anger that the outer element will be The seal portion on imitation pa rts lacks precision, and allows the entry of dust, which leads to damage of the engine. Do not use such imitation parts. 9. Before installing the outer element, check that the inner element is fitted securely. If th fitted securely, push it in pr operly. ement i s not