. MAINTENANCE SERVICE PROCEDURE 4 - 31 4. Remove the cutti ng edge and the end bit and clea n th e mounting surface. 5. Reverse or repla ce the cutting ed ge and the end bit when worn ou 1) Remove nut (1) and bolt (2), and the end bit. reverse th cutting edge 2) Install the cu tting edge on the temporarily. e against eliminate the specified torq bol ground t th Nut tightening torque Straigh t tilt dozer : 39 2 - 530 Nm (40 - 89 - 391 l bft. Angle d ozer : 392 - 5 dozer : 392 - 30 Nm (40 - 54 k gm , 289 - kgm , 289 - 391 l bft.) Sigma 530 Nm (40 - 54 391 lbft.) Power angle power ti 30 Nm (40 - 54 391 l bft.) If bolt ( 2) and nut (1) are damaged, re place them with new ones at the same t ime.
6. Afte r several hou rs of running, ret ourque the nuts