. MAINTENANCE SERVICE PROCEDURE CLEAN AND CHECK RADIATOR FINS AND OIL COOLER FINS REMARK CLEANING BY COOLING FAN REVERSE TURN "HYDRAULIC DRIVE FAN REVERSE MODE (PAGE 3-48)". 4 - 32 Carry out this procedure if th ere is any mud or dirt stuck to the radiator Check the hydraulic cooler h oses. If any hose is cracked or hardened by age, replace with a new hose. Also check and tighten all loose hose cl NOTICE the reverse direction, be extremely careful of flying dust.
When rotating the cooling fan in the reverse direction, be extremel y careful of When stopping the engine when the cooling fan is rotating in the re verse direction, first run the engin e at low idling, then stop it The dust and dirt stuck to the radiator and cooler can be blow n out by rotating the cooling fan in the reverse direction 1. Turn starting switch (1) to the "OFF" position and stop the engine. 2. Fully open the right and left engine side covers and lock them. 3. Turn starting switch (1) to the "ON" position. 2. Fully open the right and l eft engine side covers and lock them 3. Turn starting switch (1) t 4.
Set the fan reverse mod d of setting the fan reverse mod e, see REMARK When the engine is running, even if the fan rotation selector switch is operated, the direction of rotation of the fan will not chan ge. The screenshot on the right i s displayed to inform the operat or tha the direction of rotation of th e fan has not changed. llow the steps 2 and 3 above. Stop the engine once and fo