Komatsu — EVERY 50 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE LUBRICATING POWER ANGLE POWER TILT DOZER (1) (2) Pitch rod pin (2 places) Turnbuckle screw (2 places) (3) (4) Center ball (1 place) U-frame trunnion (2 places) 4 - 54 1. Lower the blade to the grou nd, then stop the engine. 2. Only when lubricating the lif t cylinder support shaft, lower the blad e to raise the idler 1to 2 cm from the ground, then stop the engine. 3. Using a grease pump, pum p in grease through the grease fi ttings shown by arrows. 4. After greasing, wipe off any old grease that was pushed out