Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE LUBRICATING STRAIGHT TILT DOZER, SIGMA DOZER 4 - 55 EVERY 250 HOURS SERVICE Maintenance f or every 50 hours service should be carried out at the 1. Lowe r the blade to the ground, then stop the engine. 2. Only when lubricat ing the lift cylinde r suppor t shaft, lower the blade to raise the id ler 1to 2 cm from the ground, then stop the engi 3. Using a gr ease pu mp, pump in grease through the greas e fittings shown by arro 4. After greasing, wip e off any old grease that was pushed o ut.

(1) Lift cylinde r suppor t yoke (4 (2) Lift cylinde r suppor t shaft (2 places) (3) Lift cylinde r ball joi nt (2 places) nt (1 place) (1 place) laces) (4) Tilt cylinde r ball joi nt (1 place (5) Tilt brace b all joint (6) Brace ball joint (2 p laces) (7) Tilt brace t hread (1 place) (screw-adjustable)