DEUTZ AG — DEUTZ AG Werkstatthandbuch Motorreparatur und Wartung

Bauteile instand setzen PEMOHT УЗЛОВ Repair of components Zylinderkurbelgehдuse БЛОК ЦИЛИНДРОВ Crankcase with integrated cylinder liners РУССКИЙ English 21. Вставить инструмент для снятия так, чтобы болт вошел в зацепление в отверстии. 21. Insert puller until pin engages in bore. 22. Установить распорную втулку. Вытянуть трубу из нижней прессовой посадки. 22. Position spacer bush in place. Pull out pipe from lower press fit. Указание: Вытягивать трубу не полностью. Note: Do not pull out pipe completely. 23. Вставить болт нажатием так, чтобы он не возвышался над трубой. Теперь полностью вытянуть трубу. 23. Press pin in until it does no longer project beyond the pipe.

Now pull out pipe completely. 3 24. Выбить направляющую втулку спереди. 24. Drive out guide bush at front end. © 2001 / 0297 9811 3.01.07