Komatsu — Securing The Dump Body

OM2049 2/13 Safety - Section 20 Page 20-7 Warning Tag Never start the engine or operate the controls while a person is performing maintenance. Serious injury or death may result. Securing The Dump Body To avoid serious personal injury or death, the body retention sling must be installed whenever personnel are required to perform maintenance on the truck while the dump body in the raised position. The Komatsu body-up safety sling can only be used with a Komatsu body. Non-OEM body may not accommodate the Komatsu body-up safety sling. The end user must ensure that a proper cable/sling is used.

Always attach a warning tag to the control lever in the operator's cab to alert others that you are working on the machine. Attach additional warning tags around the machine, if necessary. These tags are available from your Komatsu distributor. Part No. 09963-03001 Proper Tools 1. To hold the dump body in the up position, raise the body to it's maximum height. Use only tools suited to the task. Using damaged, low quality, faulty, or makeshift tools can cause personal injury. 2. Install two shackles (2, Figure 20-3) and body retention sling (3) between rear body ear (1) and the axle housing. 3. Secure the shackle pins with cotter pins. 4.

Move the hoist lever to the FLOAT position to slowly lower the body until the cable is support- ing the full weight of the body. Then move the hoist lever to the HOLD position. Extra precaution must be used when grinding, welding, and using a sledge-hammer. 5. After maintenance work is completed, return the sling to stored position. Use of Tie-Off Anchor During Maintenance While working at heights during assembly, mainte- nance or repair of the haul truck, workers should wear an appropriate fall protection harness and attach it to a tie-off anchor or tie-off point. Komatsu anchor (58B-98-75190) is available for use with fall protection harnesses.

Carefully read and understand the harness maker's instructions before using any fall protection harness. The load carrying capacity of anchor (58B-97–75190) is 2 270kg (5,000lbs). NOTE: The anchor must not be used for lifting. FIGURE 20-3. BODY RETENTION SLING INSTALLATION 1. Rear Body Ear 2. Shackle And Pin 3. Body Retention Sling