Safety - Section 20 2/13 OM2049 Page 20-8 DURING MAINTENANCE Use extreme care when washing the electrical control cabinet. DO NOT allow water to enter the control cabinet around the doors or vents. DO NOT allow any water to enter the cooling air inlet duct above the electrical control cabinet. If water enters the control cabinet (through any opening or crevice) major damage to the electrical components may occur. Personnel Only authorized personnel can service and repair the machine. Attachments Place attachments that have been removed from the machine in a safe place and manner to prevent them from falling. Never spray water into the rear wheel electric motor covers.
Damage to the wheel motor armatures may occur. DO NOT spray water into the retarding grids. Excess water in the retarding grids can cause a ground fault, which will prevent propulsion. Working Under The Machine Always lower all movable work equipment to the ground or to their lowest position before performing service or repairs under the machine. Never work under the machine if the machine is poorly supported. Always block the tires of the machine securely. Use Of Lighting When checking fuel, oil, coolant, or battery electrolyte, always use lighting with anti- explosion specifications. If lighting without this protection is used, there is a danger of explosion.
Keeping The Machine Clean If equipped, DO NOT aim high pressure spray equipment at or near the Retractable Ladder Sys- tem (RLS) power pack, actuator box, bearings or electrical harnesses. Moisture introduced in the electrical harnesses may result in uncontrolled ladder movement. Precautions With The Battery Before repairing the electrical system or when performing welding, turn the key switch to the OFF position. Wait two minutes after the engine has stopped, and if no warning lights illuminate, then turn the master disconnect switch (3, Figure 20-2) and starter disconnect switch (4) located in the isolation box (6) to the OFF position.
When the switches are in the OFF position, LED lights (8) will be illuminated. Spilled oil, grease, scattered tools, etc. can cause you to slip or trip. Always keep your machine clean and tidy. If water gets into the electrical system, there is danger that the machine may move unexpectedly and/or damage to components may occur. DO NOT use water or steam to clean any sensors, connectors, or the inside of the operator's compartment.