OM3072 2/13 Operating Instructions - Section 30 Page 30-3 Attenuators General Attenuators are fitted in various places around the engine compartment to muffle the noise. A typical attenuator is made of up numerous perforated split- ters (2, Figure 30-2). Each splitter is filled with a spe- cial insulation pillow (3, Figure 30-3). Periodically, the attenuators need to be inspected and disassembled for maintenance. Refer to Sound Attenuation System Service for inspection and main- tenance intervals. The insulation pillow should have a protective cloth between the insulation and the perforated cover. The insulation should be clean, soft, and free from debris.
The insulation should be of consistent density, and fill the cavity completely, not slumping to the bottom. Remove any debris, oil, or grease present in the sys- tem as required. Never use a pressure washer to clean an attenuator, as damage to the protective cloth and the insulation may result. FIGURE 30-2. TYPICAL ATTENUATOR ASSEMBLY 1. Housing 2. Splitter (Perforated) 3. Insulation 4. Baffle 5. Spacer 6. Cap Screw Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators. FIGURE 30-3. ATTENUATOR CROSS SECTION VIEW 1. Housing 2. Splitter (Perforated) 3. Insulation Pillow