Komatsu — Maintenance

Operating Instructions - Section 30 2/13 OM3072 Page 30-4 Engine Side Panels NOTE: If a significant amount of damage or soiling of any of the parts has been observed, replacement insulation pillows must be installed to ensure correct performance of the parts. General Both sides of the engine bay have been enclosed with attenuator panels (8, Figure 30-4), and access doors (7) for maintenance personnel. 3. With the insulation pillows removed, use a pres- sure washer only on the metal parts. Remove all of the debris, oil, or grease present on the parts. Maintenance 4. Reassemble and reinstall the pack. Repeat for the remaining packs.

Refer to the Sound Attenuation System Service sec- tion for periodic inspection requirements. Approximate weights Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators. Always use a lifting device that can handle the load safely. Lifting lugs are fitted to the top of the attenuator housings (8). Access Door Assembly - 54 kg (119 lb) Periodically, the attenuators need to be disassem- bled for maintenance. Refer to Sound Attenuation System Service for maintenance intervals. Follow the steps below to service the attenuators. Side Exhaust Attenuator LH - 81 kg (179 lb) Side Exhaust Attenuator RH - 70 kg (154 lb) 1.

Remove the attenuator housing (8, Figure 30- 4). Once on the ground, the splitter packs can be removed as a unit. 2. Remove the perforated cover to gain access to the insulation pillow and remove the pillow. The pillow should have a protective cloth between the insulation and the perforated cover. The insulation should be clean, soft, and free from debris. The insulation should be of consistent density, and fill the cavity completely, not slump- ing to the bottom.