Komatsu — Approximate weights

OM3072 2/13 Operating Instructions - Section 30 Page 30-7 Maintenance Refer to the Sound Attenuation System Service sec- tion for inspection requirements. Approximate weights Always use a lifting device that can handle the load safely. Lifting lugs are fitted to the top of the attenuator housings (8). Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators. Front Door Assembly (7)- 38 kg (84 lb) Rear Door Assembly (6) - 41 kg (90 lb) Front Attenuator Assembly (8) - 104 kg (229 lb) Periodically, the attenuators need to be disassem- bled for maintenance.

Refer to Sound Attenuation System Service for maintenance intervals. Follow the steps below to service the attenuators. 1. Remove the cap screws securing the front attenuator assembly to the frame. Then allow it to swing down, then remove it by lifting it out of the hinge. Once on the ground, the splitter packs can be removed as a unit. 2. Remove the perforated cover to gain access to the insulation pillow. The pillow should have a protective cloth between the insulation and the perforated cover. 3. The insulation should be clean, soft, and free from debris. The insulation should be of consis- tent density, and fill the cavity completely, not slumping to the bottom. NOTE:

If a significant amount of damage or soiling of any of the parts has been observed, replacement parts must be installed to ensure correct performance of the parts. FIGURE 30-6. ENGINE BELLY PAN DOOR OPEN 1. Seal 2. Hinge 3. Cover (Perforated) 4. Mylar 5. Insulation 4. With the insulation pillows removed, use a pres- sure washer only on the metal parts. Remove all of the debris, oil, or grease present on the parts. 5. Reassemble and reinstall the pack. Repeat for the remaining packs. 6. Position the attenuator assembly below the truck, then raise it so it is hanging on the hinges. Then swing the unit up into place.

When closing the attenuator assembly, a hand crush hazard is present in between the door and body. Be aware of hand position when closing the doors. Install mounting hardware securely.