Komatsu — Approximate weights

Operating Instructions - Section 30 2/13 OM3072 Page 30-8 Radiator Silencer Periodically, the attenuators need to be disassem- bled for maintenance. Refer to Sound Attenuation System Service for maintenance intervals. Follow the steps below to service the attenuators. General Sound attenuators have been added to the front of the radiator. The ladder has been brought forward, which has meant the front bumper has been extended forward to accommodate. 1. Remove the four cap screws on the front of a splitter and remove the cover. The covers should be compact enough for easy handling. 2. Remove the cover to gain access to the insula- tion pillow.

The pillow should have a protective cloth between the insulation and the perforated cover. The insulation should be clean, soft, and free from debris. The insulation should be of consistent density, and fill the cavity completely, not slumping to the bottom. NOTE: If a significant amount of damage or soiling of any of the parts has been observed, replacement parts must be installed to ensure correct performance of the parts. 3. With the insulatino pillow removed, use a pres- sure washer only on the metal parts. Remove all of the debris, oil, or grease present on the parts. FIGURE 30-7. RADIATOR SILENCER 4. Reassemble and reinstall the splitter pack. Repeat for the remaining splitter packs.

1. Top Attenuator 2. Splitter 3. Insulation 4. Lower Attenuator Approximate weights Maintenance Refer to the Sound Attenuation System Service sec- tion for inspection requirements. Always use a lifting device that can handle the load safely. The radiator attenuators require a crane for installation & removal. Lifting eyes are provided on top of the radiator under- neath the cover, and between the top and bottom rows of attenuators behind where the lights are installed. Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators.

Upper Radiator Attenuator - 525 kg (1,157 lb) Lower Radiator Attenuator - 525 kg (1,157 lb)