OM3072 2/13 Operating Instructions - Section 30 Page 30-9 Rear Engine Compartment Enclosure protective cloth between the insulation and the perforated cover. The insulation should be clean, soft, and free from debris. The insulation should be of consistent density, and fill the cav- ity completely, not slumping to the bottom. Remove any debris, oil, or grease present in the system as required. General There are acoustic panels located on the lower struc- ture (4, Figure 30-8) and a discharge attenuator (3) fitted into the horse collar opening. The entire assem- bly is isolated from the engine module. Maintenance NOTE:
If a significant amount of damage or soiling of any of the parts has been observed, replacement parts must be installed to ensure correct performance of the parts. Refer to the Sound Attenuation System Service sec- tion for inspection requirements. 3. With the insulation pillow removed, Uue a pres- sure washer only on the metal parts. Remove all of the debris, oil, or grease present on the parts. Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators. 4. Reassemble and reinstall the splitter. Repeat for the remaining splitters. Periodically, the attenuators need to be disassem- bled for maintenance.
Refer to Sound Attenuation System Service for maintenance intervals. Follow the steps below to service the attenuators. Approximate weights 1. Remove the attenuator housing. Once on the ground, the splitter packs can be removed as a unit. Always use a lifting device that can handle the load safely. Lifting lugs are fitted to the top of the attenuator housings. 2. Remove the perforated cover to gain access to the insulation pillow. The pillow should have a Rear engine discharge attenuator - 151 kg (332 lb) FIGURE 30-8. REAR ENGINE ENCLOSURE 1. Mud Flap 2. Seals 3. Attenuator 4. Lower Structure