. OPERATION OPERATION CHECK COOLANT LEVEL, ADD COOLANT WARNING 3 - 72 CHECK BEFORE STARTIN Perform the contents of this se ction before starting the work of each Do not open the sub-Tank cap u nless necessary. Wait for the engine to c ool down before checking the coolant in the Reservoir tank. Immediately after the engine is s topped, the coolant is at a high temperatur e and the sub-tank is u nder high internal pressure. If the cap is removed to check t he coolant level in this condition, there is a hazard of burns. Wai t for the temperature to go down, then turn the cap slowly to release the pressure before removing it. 1.
Open the engine hood and check that the coolant in reservoir tank (1) is between the FU LL and LOW marks. 2. If the level is LOW, remove up to the FULL mark. cap (2) and add the engine coolant 3. If there is no coolant in res coolant whose density is coolant in "CLEAN INSID 4-28)" through water filler ( the reservoir tank with the ervoir tank, fill the sub-tank with the indicated in the density table of E OF COOLING SYSTEM (PAGE 3) at the top of radiator and then, fill coolant as well. in the engine coolant or any other n the cap securely. han normal, then check for water 4. Check that there is no oil problem. 5. After adding coolant, tighte 6. If more coolant is added t leakage.
CHECK DUST INDICATOR 1. Check that the red line i indicator (1) does not ind (0.076 kg/cm2, 1.1 PSI). 2. If the red line indicates 7.5 k 2, 1.1 PSI), clean or r immediately. For details of the metho "CHECK, CLEAN OR R 4-22)". 3. After checking, cleaning, o indicator (1) to return the re n the transparent portion of dust icate 7.5 kPa (30 INCHES H2O) Pa (30 INCHES H2O) (0.076 kg/cm 2. If the red line indicates 7.5 k eplace the air cleaner element d of cleaning the element, see EPLACE AIR CLEANER (PAGE r replacing, press the top of dust d line to its original position.