Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING oil level with marks on the If the oil is below the L mark, add oil through oil filler (F). valve (2) to oil filler cap securely. 3 - 73 Immediately after the engine i s stopped, its parts and oil are still very hot, an d may cause burn injury. Accordingly, wait until they have cooled down before star ting the work. 1. Ope 2. 3. Take Fully out dipstick (G) a insert dipstick (G nd wipe off the oil with clo ) into filler pipe, then remo The oil level should b ENGINE STOPPED s e between the H and L m ide of dipstick (G). 5.

I f the oil level is above the H mark, open the unde engine, remove drain plug (1), and loosen drain drain the excessive oil , and then check the oil lev 6. I f the REMARK When checking the oil l evel after the engine has b een operated , wait for at least 15 m inutes after stopping the engine. angle, make it horizontal before checking. il level marked on both sides: ENGINE STOPPED for measuring when the engine is IDLING for measuring when the engine is idle. evel, stop the engine and check with the ENGINE STOPPED side of the dipstick. eck when the engine is idle, but the following procedure must be used. water temperature is in the white range. ING side of the dipstick. ap.

If the machine is at an angle, make it horizontal b efore checking The d ipstick has the o il level marked on both si des: ENGINE stopped, and ENGINE IDLING for measuring whe n the engine i When checking the oil l evel, stop the engine and check with the It is al so possible to ch eck when the engine is idle , but the following procedure must b • Check that the engine water temperature is in th e white range • Use the ENGINE IDL • Remove the oil filler c