. OPERATION OPERATION STARTING ENGINE WARNING REMARK When the key of the starting switch is turned to ON position, if the engine coolant temperature is -5 ° C (23 ° F) or higher, the engine is not pre-heated. At this time, the engine can be started without pre-heating operation. 3 - 85 Start t he engine only after sitting down in the operator's seat. Do no t attempt to start the engin e by short-circuiting the engine s tarting circuit. Such an act may cause a serious bodily injury or fire Check that there are no persons or obstacles in the surrounding area, t he n sound the horn and Never use starting aid fluids as t hey may cause explosions Exhaust gas is toxic.
When start ing the engine in confined space s, be particularly careful to ens NOTICE t accelerate the engine sharply until it is warmed up. t operate the starting motor continuously for more than 20 seconds. engine fails to start, wait for 2 minutes or so, and then try to start again. Do no t accelerate the engine sha Do no t operate the starting moto r continuously for more than 20 seconds. If the engine fails to start, wait fo r 2 minutes or so, and then try t o start When starting the engine, do not depress the accelerator pedal. E ven if t he accelerator pedal is de pressed just after the engine is started, the engine speed is li mited by the turbo protect functi on.
After the turbo protect time , however, the engine speed rises s harply and the turbocharg er may be damaged. 1. Turn the key of starting swit ch (1) to ON position. hts up, depending on the engine he engine is preheated. After the ater pilot lamp goes off. c p The preheater pilot lamp lig oolant temperature, and t re-heating time, the prehe The pre-heating times are a Engine water temperature Preheating time above - 5°C (23°F) – - 5°C to - 20°C (23°F to - 4°F) 20 to 40 sec below - 20°C (- 4°F) 40 sec