. OPERATION OPERATION OPERATION OPERATION 2. After the preheater pilot lamp goes off, turn the key of the Just after the engine starts, the injection characteristics are changed for a certain time to keep the low idle speed a little high, depending on the engine coolant temperature. The engine acceleration characteristics are also changed so that the engine will be accelerated moderately. 3 - 86 itch to START posi tion, and the e ngine will st REMARK When starting the engine, the mon itor may flash while the st arting motor is turnin g, but if the monitor lamp goes ou t after ngine is started, the re is no problem. 3. After the e ngine starts, releas e the key of th e starting s witch.
REMARK If the engine f ails to start, return the key of the starting switch to If OFF position, and then start the op eration again from s tep 1. If the starting switc h is not returned t s not operate. o OFF position, the automatic matic preheater doe 4. Just after t he engine starts, do not depress th e accelerat or peda l but run the engine idle at low speed fo r at l east 15 second When the idle run fo s. engine is started for the first time after t he en gine oil or engine oil filter is repl aced, continu e the low r at least 20 second s to circulate t he engine o il in the engine. REMARK Since the t urbocharger rotates at very high speed, it is seized if not lubricated well.
To prevent this, the turbo urbo protect me temperatur chanism works for a certain time just after the engine starts, depending on the engine coolant e. Engine water temperature Turbo protect time above 10°C (50°F) 0 sec -10°C to 10°C (14°F to 50°F) 0 to 5 sec below -10°C (14°F) 5 sec Engine water temperature Injection characteristics change time above 20°C (68°F) 0 sec 0°C to 20°C (32°F to 68°F) 0 to 6 sec -20°C to 0°C (-4°F to 32°F) 6 to 12 sec -30°C to -20°C (-22°F to -4°F) 12 to 15 sec