Komatsu — OPERATIONS, CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION OPERATIONS, CHECKS AFTER STARTING ENGINE BREAKING-IN THE MACHINE CAUTION WARMING-UP OPERATION 3 - 87 Your Komatsu m achine has been thoroughly adjust ed and tested before shipme nt. However, operating th e machine und er severe conditions at th e beginning can adversely affect th e performance and shorten the machine l Be sure to brea k-in the machine for the initial 100 h ours (as indicated by the se rvice meter). During break-in operations, follow the precautions described in this manual. Idle the eng ine for 5 minutes after starting i t up. speeds.

Avoid oper ation with heavy loads or at high Immediatel y after starting the engine, avoid sudden starts, sudden a cceleration, unnecessa ry sudden st ops, and sudden cha nges in direction. NOTICE Do not accel erate the engine sharply during the warming-up operation. Sha rp acceleratio n ca n short en the service life of the engine parts. Do not conti nue the low idle or high idle operati on for more than 20 minutes . It can cause oil l eakage from the turbo charger. 1. After the e 2. Check tha the white r If the engi range (ab If the engi the white operation After finis machine If the ma distributor 1.

After the e ngine starts, run it for 5 minute s in the range between lo w idle and medium sp eed to warm 2. Check tha t the engine water temperature ange (above (A)). ne water temperature gauge p ove (A)), the engine is warmed ne water temperature gauge poi REMARK While the AIS S switch is in AUTO position an d the engine water temperature i s low , the low id le speed is s et a little high automati cally. 3. Check tha t the steering operation is norm al, the lamps light up an d go of f normally , the horn sounds, and the exhaust g inspection as color, sound, and vibration ar e normal. If any of them i s abnormal, ask your K omatsu distri butor for /repair.