. OPERATION DETERMINING AND MAINTAINING TRAVEL ROAD 3 - 117 DETERMINING AND MAIN Determining and traveling the road in the j obsite is an extremely important factor both for reasons of s afety and for reducing the cycle time. To ensure safety DETERMINING TRAVEL ROAD ad to one-way travel. As far as possible, restrict the travel ro If it is impossible to keep to one-way tra ffic, make the road with ample width to enable truck s travelin g in opposite directions to pass each other. If it is i various points along the road. mpossible to provide a sufficient road width, provide passing places at ded truck passes on the side closest to the hill face. ong the road, set up mirrors.
Always design the road so that the loa ded truck passes on the side closest to the hill face If there are curves with poor visibility al In places where the road should is weak or likely to collapse, set up a sign at a point at least 1.5 m (4 ft 11 in) from the road shoulder to warn of the dange r. tors to enable the road to be traveled at night. It is important to set up lighting or reflec The grade of slope should be kept withi n 10% (approx. 6 deg.) as far as possible, and emergency es cape points should be set up on downhill slopes in case of any brake failure.
Make the road as straight as possible, and particularly in intermediate areas with curves, where the machine is traveling at high speed, make the radiu s of the curve as large as possible. Small S curves are particularly dangero us, so avoid such curves. The radius of the curve m ust be a minimum of 12 to 15 m (39 ft 4 in to 49 ft 3 in). ossible. in straight areas. igher. road shoulder on the outside of curves. that no other roads cross it.
In particular, if roads cross at an angle on Make the radius of curves as large as p Make the road wider at curves than it is Make the outside of the curve slightly h Be particularly careful to strengthen the As far as possible, design the road so on slopes, a stepped difference is formed i n the road. This is extremely dangerous, as it causes the ma chine to r oll when traveling at high speed. road for the trucks. Cut the slope face to provide a special MAINTAINING TRAVEL ROAD Perform the necessary action according t o the conditions to insure that the road can always be travel ed in safety.
Remove any unevenness in the travel s urface, sloping to the left or right, or drooping of the road sho ulder. Make the road of ample strength and remove such obstacles as rocks and tree stumps. a bulldozer or motor grader. tervals to prevent dust from rising and reducing the visibility. Maintain the road from time to time with Spray the road with water at suitable in tervals to prevent dust from rising and reducing the visibility