. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE NOTICE If the machine has been stored without performing the monthly rust-prevention operation, consult your Komatsu distributor before using it. 3 - 127 BEFORE STORAGE (more than 1 month), store as follows. use the machine in a dry building. Never leave it outdoors. tdoors, select a flat area and cover the machine with a waterproof sheet. s prevents moisture from collecting. ore storage. hydraulic cylinder piston rod with grease. When keeping in long-term storage Wash and clean all parts and ho use the machine in a dry building. Never leave i t outdoors.
If the machine must be stored ou tdoors, select a flat area and cover the machine with a waterproof she Completely fill the fuel tank. Thi Lubricate and change the oil bef Coat the exposed portion of the Disconnect the negative terminal s of the battery and cover it or remove it from the m achine and store i t separately. Apply the parking brake. Set the tire inflation pressure for each tire to within the range of the specified inflati on pressur e fo r the typ e of tire. Push the retarder control lever fo rward to OFF position. eutral) position and turn the starting switch OFF. o give a density of at least 30% for the engine coolant.
Place the gear shift lever at N (n eutral) position and turn the starting switch OFF. To prevent rust, fill with coolant t o give a density of at least 30% for the engine c If it is necessary to perform the rust-pre vention operation while the machine is indoors, open t he doors and windows to improve ventilation and prevent gas poisoning. During the storage period, operate the machine once a month to prevent loss of the oil film at t he l ubricate d parts. At the same time, charge the batte ry. nt, wipe off all the grease from hydraulic piston rods. Before operating the work equipme nt, wipe off all the grease from hydraulic piston r ods.
When using the machine after long -term storage, do as follows before using it. raulic cylinder rods. ion points. Wipe off the grease from the hyd Add oil and grease at all lubricat When the machine is stored for a long period, moisture in the air will mix with the oil. Check the oil before a nd after starting the engine. If there is w ater in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORA 1. Check all the oil and water leve 2. When traveling after long-term s or 1 km to run the machine in, t torage, travel forward at a speed of 10 to 15 km/h (6.2 to 9.3 MPH) f or 5 minutes hen change to normal travel.