. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION air a 3 - 128 AFTER RUNNING OUT If you have run out of fuel, ad d fuel to the fuel tank and bleed air from the fuel system and The fuel injection pump and n ozzle of this engine consist of more p recise parts than the conventio nal ones. If foreign matter enters them, it can cause a tro uble. Accordingly, if dust sticks to t he fuel system, wash it off with When opening the air bleedin g plug at the fuel filter head, take care . Fuel may spout because of r 1. 2. Fill the fuel tank with fuel. Loosen air bleeding plug Do not loosen the plug at it is loosened, air is not bl (1) at the fuel main filter head.
the filter stand of the fuel prefilte ed. 3. Loosen wing bolt (3) whi (2). Move lever (4) up a bleeding plug (1) until bu ch is fixing lever (4) of priming pu nd down to let fuel flow out of bbles do not come out any more. 4. Tighten air bleeding plug (1) and then tighten wing bolt (3 y to lock lever (4). ir bleeding plug gm} ing screw .3kgm, 5.1 to 9.4 lbft} priming pump (2) securel Tightening torque for a 7.8 to 9.8Nm {0.8 to 1k Tightening torque for w 6.9 to 12.7Nm {0.7 to 1 priming pump (2) securel Tightening torque for a 5. Turn the key in the startin g switch to START position and s the engine. When doing this, do not c rank the starting motor continuou for more than 20 seconds .
If the engine does not start, wait at least 2 minutes, then maximum of 4 times. try again. Perform this operatio 6. If the engine does not sta rt, repeat the procedure from ste