Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING PRECAUTIONS FOR CHARGING BATTERY STARTING ENGINE WITH BOOSTER CABLE When starting the engine with a booster cable, do as follows. PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE WARNING a booster cable, wear protective in the booster cable connections. 3 - 135 CHARGING BATTERY WHEN MOU NTED ON MACHINE he battery is mistakenly handled, Follow the precautions in "IF GE 3-134)" and the instructions always do as follows. o match the voltage of the battery ltage is not selected, the charger plosion. rger clip of the charger to the ery, then connect the negative (-) the negative (-) terminal of the lips securely.

When the charging the battery, if t there is danger of explosion. BATTERY IS DISCHARGED (PA given in the charger manual, and Set the voltage of the charger t to be charged. If the correct vo may overheat and cause an ex Connect the positive (+) cha positive (+) terminal of the batt charger clip of the charger to battery. Be sure to attach the c Set the charging current to 1/1 0 of the value of the rated battery capacity; when perform ing rapid charging , set it to less than the rated battery capacity. If the charger current is too high , the electrolyte will leak or dry up, and this may cause the battery to catc h fire and explode.

If the battery electrolyte is froz en, do not charge the battery or start the engine with a different power source. ignite the battery electrolyte and cause the battery to explode. There is a danger that this will ignite the battery electrolyte and caus e the battery to exp Do not use or charge the batte ry if the battery electrolyte level is belo w LOWER LEVEL l ine. This may c aus e an explosion. Check the battery e lectrolyte level periodically and add distilled water to bring the electrolyt e lev el to UPPER LEVEL line. When connecting the cables, never (-) terminals. When starting the engine with eyeglasses and rubber gloves. Be careful not to let the normal ma each other.

This prevents sparks fr could ignite the hydrogen gas give Make sure that there is no mistak The final connection is to the engin sparks will be generated when this as possible from the battery. When disconnecting the booster c in contact with each other or with NOTICE The size of the booster cable and The battery of the normal machine must be the same capacity as that of the p Check the cables and clips for dam Make sure that the cables and clip