Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WARNING drained during repair of the distilled water, see a little to release the remaining Run at low idle for 10 minutes to raise the water temperature to above 90 ° C (194 ° F). 7. Stop the engine, open drain valve (3) and drain the water. After the coolant density, see 4 - 29 Coolant is toxic. When open th e drain valve, be careful n ot to get c oolant on you. If it gets in you large am ount of fresh water an d see a doctor at once.

When c hanging the coolant or when handling the cooli ng water c ontaining coolant that has be radiator , contact your Komats u distributor or request a s pecialist co mpany to perform the operat let it flo w into drainage ditches or spray it onto the grou nd surface. Coolant i s already diluted w ith distilled water, so it is not fl ammable. (For details of "COOLAN T AND WATER FO R DILUTION (PAGE 4 -5)"). Che ck the density with a coola Prepare a container that is a l arger than the specifie d amount of coolant, then drain the c Prepare a hose to use when r efilling with coolant. 1. Stop t 2. Open underguard (1) unde r the engine and pull o ut the cool drain 3.

Loose press ure and then remov 4. Open drain valve (3) in th e oil cooler and drain th e coolant. 5. 6. After water Fill th start t draining the water, close drain valve (3) and fill with c . e radiator, sub-tank and reservoir tank with water, th he engine and run at low idle. draini ng the water, close i 8. Add c oolant through the "COOLANT DENSITY TA 9. To re move the air contain ed in the coolant, run th e engine a t low idle for 5 minutes, the 5 min utes. (When doing t his, leave the coolant fi ller cap O FF.) 10. Stop t he engine. Approx. 3 minutes later, supply the coola nt up to the coolant filler, th