. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM FRONT BRAKE WARNING Stop the machine on level ground and put blocks under the wheels before bleeding the air. same as for the slack adjuster (with step 4 excluded). NOTICE The brake oil pressure caution lamp may light on during air bleeding. In that case, tighten the bleeder screw and check sight gauge (H) to see if some oil remains in the brake oil tank. If there is no oil left, stop the engine and fill with oil. (When the engine stops, the oil level rises and the brake oil tank is automatically refilled with oil.) 4 - 33 To make it easier to bleed the air, warm the oil up to a temperature of at least 40°C (104°F) before bleeding the air.
Bleed the air from the front br akes in the same way on both the left and right sides. 1. Start the engine, check th at the oil in the transmission case is the specified level, and check if the retarder oi pressure caution lamp is o 2. Remove the cap installed adjuster, then insert a viny Prepare a container with o hose approx. 50 mm (2.0 i (Use any commercially av 3. Depress the brake pedal a 3/4 turns. Keep the peda come out from the vinyl ho 4. Pull the retarder control l approx. 3/4 turns. Keep t until no more bubbles com 5. After bleeding the air, tight en bleeder screw (1) securely and the cap. 6. The procedure for bleede 7.
After finishing air bleeding, and adjust the oil level so t details, see "CHECK OIL ADD OIL (PAGE 3-74)". hat it reaches the specified level. F