. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM CENTER BRAKE WARNING and fill with oil. (When the engine stops, the oil level rises and the brake oil tank is automatically refilled with oil.) 4 - 34 Stop the machine on level gro und and put blocks under the wh eels before To make it easier to bleed the air, warm the oil up to a te mperature of at least 40°C (104°F) bef ore bleeding the air. Bleed the air from the cent er brakes in the same way on both t he left and right sides. 1. Start the engine, chec k that the oil in the transmissio n cas e is the specified level, and ch eck if the retarder oi pressure caution lamp 2.
Remove the cap insta adjuster, then insert a Prepare a container wi hose approx. 50 mm ( (Use any commercially 3. Depress the brake ped al and loosen bleeder screw (1 ) approx. 3/4 turns. Keep the p come out from the viny edal depressed until no more bubbles l hose. ol lever and loosen bleeder screw (1) ep the retarder control lever depressed 4. Pull the retarder contr (1) approx. 3/4 turns. Ke until no more bubbles epressed come out from the vinyl hose. 5. After bleeding the air, ti ghten bleeder screw (1) secur ely and fit the cap. 6. The procedure for blee der screw (2) of the center bra ke is t he same as for the slack adjuster (with step 4 excluded).
adjuster (with step 4 excluded th oil in it and insert the other e nd of t he 2.0 in) below the surface of the NOTICE n lamp may light on during air bleeding. In screw and check sight gauge (H) to see if oil tank. If there is no oil left, stop the engine The brake oil pressure cautio that case, tighten the bleeder some oil remains in the brake eeding. In ) to see if he engine 7. After finishing air bleed ing, stop the engine (for 2 to 3 minutes), and adjust the oil level details, see "CHECK O ADD OIL (PAGE 3-74) so that it reaches the specified level. F or IL LEVEL IN TRANSMISSION CASE, ".