. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING 4 - 57 EVERY 500 HOURS SERVIC E Maintenance for every 50 and 250 hours service should be carried out at the same time Immediately after the engine is stop ped, its parts and oil are still very hot , and may cause burn i njury. Accordingly, wait until they have cooled down before starti ng the work. Refill amount of oil: 50 liters (13 Prepare a filter wrench 1. Remove the bolts and cover (1 2. Place a drain oil container just 3. Remove drain plug (2), then l oosen drain valve (3) slowly to d drain the oil.
Be careful not to nd deform the stopper pin inside if there are excessive metal ntact your Komatsu distributor. in plug (2). 8.6 ± 9.8 Nm 7 ± 1 kgm , 50.6 ± 7.2 lbft) filter cartridge (4) to the left to getting oil on yourself, do not mediately under the cartridge. s carried out immediately after ount of oil will come out, so wait he operation. ew filter cartridge with oil, coat h oil (or coat thinly with grease), n doing this, be careful not to damage the outside cylinder of the cartridge. avoid getting oil on yourself, an loosen the drain valve too far a the valve. Check the drained oil, and 4. particles or foreign material, co 5.
Tighten drain valve (3) and dra Tightening torque Drain plug (2), drain plug (3): 6 ( 6. By using the filter wrench, turn remove it. When doing this, to prevent perform this operation from im In particular, if this operation i stopping the engine, a large am for 10 minutes before starting t 7. Clean the filter holder, fill the n Tightening torque Drain plug (2), drain plug (3): 6 6. 7. In particular, if this operation i stopping the engine, a large am for 10 minutes before starting t Clean the filter holder, fill the n the packing face and thread wit then install the filter cartridge. 8. Install the filter cartridge.
Whe n doing this, be careful not to damage the outside cyli When installing the filter cartrid ge, tighten until the packing face is in contact with the filter holder, then tighten a further 3/4 to 1 turn. f engine oil from oil filler (F). e at idle, then check the oil if it is filled up to a specified level. For details, see NE OIL PAN, ADD OIL (PAGE 3-73)". 9. Pour in the specified amount o 10. Run the engine for a short tim "CHECK OIL LEVEL IN ENGI